Guitar Tune-Up Shops Lawrence KS
Electronic Keyboard, Drums & Percussion, Sound Reinforcement, Recording Equipment, Guitars & Fretted Instruments, Print Music
Website Sales: Yes
Instrument Repair Information
Our four luthiers handle everything from simple repairs to extensive restoration work and appraisals. If it can be fixed, we can do it, and do it exceptionally well.
Our website at www.massstreetmusic.com is open 24/7
Our regular store hours, in Lawrence, Kansas are:
M-F 10am - 6pm
Sat. 10am - 5pm
Repair shop is open to the public:
M-F 2pm - 6pm
Sat. 10am - 5 pm and by appointment.
Band & Orchestral, Drums & Percussion, Sound Reinforcement, Guitars & Fretted Instruments
Band & Orchestral, Drums & Percussion, Guitars & Fretted Instruments, Print Music
Guitars & Fretted Instruments, Print Music
Band & Orchestral, Sound Reinforcement, Recording Equipment, Guitars & Fretted Instruments
GET IN TUNE AND STAY IN TUNE
The most common questions I get involve playing in tune. If you ever hear a clicking or “tinking” when tuning, take a moment and lube your nut slots. A sharp pencil, Big Bends Nut Sauce, GHS GraphitALL, or Stewart MacDonald Guitar Grease will get the job done. I should put a sticker in every guitar case that says, “Did you remember to lube your nut today?”
Because being in tune is so important, intonating a guitar should be something every player should learn to do. If your guitar neck has too much bow in the wrong spot, or high strings at the nut, playing in tune will be a huge challenge. Adjusting your trussrod is another thing guitarists should be able to do. Unfortunately, leveling your frets and getting your nut slots the correct height is not so easily done at home, but it can make a tremendous difference in playability and tuning.
DEAL WITH YOUR CRACKLY JACK, JACK
A crackly or intermittent jack on an electric guitar, amp, or pedal can usually be fixed by rolling up a two- or three-inch piece of 320- 600 grit sandpaper into a smaller than cigarette- sized roll and sanding out the inside of the jack. Be sure to roll it up small so it will fit deep enough into the jack to sand the contact where the tip of the cable touches the jack. If you have some pot cleaner or a little oil, you can put some on the sandpaper too. The reason this works is in time, the inside of the jack oxidizes or rusts to the point that little or no contact is...